Nine9 Engraving Tool 45°

$0

NC2032:

  • Long tool life
  • For all kinds of steel from 30~50 HRC, carbon steel, alloy steel, and cast iron.

NC2071:

  • Strong edge on chip groove best suited for min. DOC 0.2 mm
  • Universal grade for all kinds of steel <30 HRC, non-ferrous metal and stainless steel.

NC9031:

  • Fully positive ground rake angle, very sharp edge for shallow engraving.
  • For non-ferrous metal such as aluminum, brass, copper, titanium, plastic and acrylic.

High Positive Rake Angle

  • Indexable insert.
  • Suitable for engraving all types of materials, such as plastic, non-ferrous metal, aluminum, copper, carbon steel and stainless steel.

Multi-Side Grinding

  • Full peripherally ground insert to ensure efficient repeatability.
  • It performs excellently without producing any burrs, especially in copper, aluminum and stainless steel.

High Speed, High Feed Rate

  • Designed to run at high speed, up to 40,000 r.p.m.
  • Feed rate 0.08mm (0.003”) / rev. apply to aluminum; 0.05mm (0.002”) / rev. apply to stainless steel.
  • Reduces engraving cycle time!

Economical

  • Each indexable insert has 2 cutting edges.
  • No resharpening required. Tool length is unchanged.
  • No need to reset after changing insert or cutting edge.
  • Excellent repeatability!

Applications

  • Serial numbers, product codes, dial scales, signs, logo, graph and almost any character which can be created by the NC programming system.
  • Widely be used for marking on machine components, medical components, gun components, mold and die, automotive parts, gears, bearings and luxury goods.

V045/V060 Series

  • Depth of per cutting Ap up to 0.8mm for carbon steel, 0.5mm for stainless steel.

Cutting Insert

NC2032:

  • Long tool life
  • For all kinds of steel from 30~50 HRC, carbon steel, alloy steel, and cast iron.

NC2071:

  • Strong edge on chip groove best suited for min. DOC 0.2 mm
  • Universal grade for all kinds of steel <30 HRC, non-ferrous metal and stainless steel.

NC9031:

  • Fully positive ground rake angle, very sharp edge for shallow engraving.
  • For non-ferrous metal such as aluminum, brass, copper, titanium, plastic and acrylic.

Tool Holder

  • Carbide shank holder designed for shrink-fit holder, engraving machines, high speed cutting.
  • XL (100mm length) is only for AI, AI-alloy cutting, unbalanced <0.6gm.

Engraving Applications Tips

Use the V045 and V060 style engravers in materials that tend to push burrs such as stainless steels and high temp alloys. These inserts have a 0.2mm(0.008”) radius with a very sharp cutting edge and cut very freely. Character widths start around 0.45mm(0.017”). This tool best replaces ball nose endmills. This tool is considered to be first choice for all but fine engraving width below 0.25mm.